Sample Request

Please complete the following information and return this sheet along with part sample and print (when available), at least 1 (one) week prior to sampling.

Company

Mold E.T.A To Target: MorningNoonNight

Tool Size

Parts

(leader, pins clear, sprue out of front half)

Type

(sub gate, tab gate, edge gate, etc.)

(hyd. Cyl., pins, blades, sleeves, lifters)

(If positive, pullback is needed)

(mech/hyd/spring-loaded) — Provide length protruding from mold

Other

Customer is responsible for proper set up of 24v ac switches on any hydraulic or moving actions. target plastics is not
responsible for damages resulting from improperly set-up or malfunctioning switches.

(ie: OUT-After Mold Open / Ejector Forward - Ejector Return / IN-before Mold Close)

(7" Center, 4"x 16", etc.)(Placement Vert/Horz/Both)

(air poppets, hand-load inserts, etc.)
Use of spray acceptableProcess sheet neededPrint supplied to targetInspection criteria supplied

(Vis/Dim)

(Rev. Change, New Mold.)
Please leave this field empty.

If you need to sample a new or existing tool, Target Plastics can assist you. Please complete our Sample Request form above. Alternatively, you can download this form as a PDF, or as an XLS spreadsheet, fill it out, and fax it to us. We will contact you to discuss the specific sample requirements and timing.